Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

UHPPOTE 9-28VDC Convencional Manual Punto De Llamada Incendio Fuego Push In Pull Down Alarma De Emergencia

Envío gratis en pedidos superiores a 25.99€

28.50€

12 .99 12.99€

En stock

1.Nombredeestilo:Modern Compact


Acerca de este producto

  • El punto de llamada manual convencional HC102 diseñado para sistema de alarma de incendio convencional para reportar el incendio o condición de emergencia por PUSH IN / PULL DOWN pestillo de manija
  • Llave cerradura disponible
  • Rango de voltaje de funcionamiento: 9-28VDC Volts
  • Pushing in y then pulling down en la manija activa el interruptor de alarma de apertura normal. Una vez enganchado en la posición hacia abajo, la palabra "ACTIVATED" aparece en la parte superior en amarillo brillante, con una porción de la manija sobresaliendo en la parte inferior como una bandera visible.
  • Nota: Todo el cableado debe cumplir con los códigos, ordenanzas y reglamentos locales aplicables.



miss g l smith
Reseñado en el Reino Unido el 1 de noviembre de 2024
I love the alarm but in the instructions it says once pulled activated will show in yellow it was never yellow and I was fuming but it’s good
aaron
Reseñado en Singapur el 1 de abril de 2024
Once I got it the spring broke and the strobe don’t even work bad product don’t recommend
Dean Neufeld
Reseñado en Estados Unidos el 13 de diciembre de 2022
My son has been fascinated with fire alarms ever since his first fire drill at school. To satisfy his curiosity I decided to build him his own fire alarm. I bought a cheap siren/strobe and this pull station and connected them with a couple op-amps and a relay in lieu of a $1500 control panel.So, the inside of this thing is a 4-way bridge rectifier. Even though there is a “+” and a “-“, it wouldn’t matter if you were to wire it backwards. The circuit is open normally, and basically passes through 2 diodes, a red LED and 1k resistor when pulled. I didn’t want to dim that LED (it’s visible externally when pulled) so I connected a 100 ohm resistor in series and amplified the voltage drop across that 100 ohms up to the point where it could switch a relay and drive the strobe. My son is happy, and this pull station worked well for me. Unfortunately I can’t tell you how it would work with a proper control panel.
Dámaso de Damasco
Reseñado en España el 14 de diciembre de 2020
Lo compré para un cuarto friki y la verdad es que está genial. Eso si, depende de la idea que tengáis, dado que es un interruptor de incendios real... necesitaréis quebraros más la cabeza xd
Gerry
Reseñado en el Reino Unido el 3 de agosto de 2019
Great piece of kit. Much easier than pushing plastic.
Duane Loya
Reseñado en Estados Unidos el 27 de febrero de 2019
I put this on a piece of wood with the siren and LED strobe light just so I can pull it any time I like for the fun of it! It works real good wires up great I have it hooked to 4 18650 batteries with a charge on it to keep it charged it is just used at a toy, but if you were replacing one of yours with it, it works great easy install has two keys. Has Loop in connections for power and to hook up another to another unit else where. very easy pull time and easy to reset if you have the key. Worth buying and I would consider buying another one!
Productos recomendados

14.21€

6 .99 6.99€

4.8
Elegir

11.42€

4 .99 4.99€

4.7
Elegir

20.49€

9 .99 9.99€

4.4
Elegir

25.35€

12 .99 12.99€

4.7
Elegir

16.43€

6 .99 6.99€

4.3
Elegir

42.22€

17 .99 17.99€

4.6
Elegir

9.00€

3 .99 3.99€

4.9
Elegir

18.00€

8 .99 8.99€

5.0
Elegir